Articles about

How an Electrical Panel Schedule will Help Locate Circuits: I need to make a panel schedule showing all my electric circuits.

How to Replace a Dining Room Fixture with a Ceiling Fan: The connections for the ceiling fan will be the same as the chandelier, except if there is a light fixture on the ceiling fan then it depends on how it will be controlled.

How to Wire 4-Way Switches: Here are some fully explained 4 way switch diagrams. 4-way switches are a convenient way to operate lighting fixtures from three or more locations.

How to Connect Grounding for Generators: The portable generator does not require a separate ground rod, however any electrical wiring enclosure including the generator transfer switch is required to be grounded to the ground system of the main panel of the home electrical system.

How to Repair a Guitar Amplifier – Prevent Electric Shock form a Guitar Amp: The important thing is to attach the ground wire to the metal chassis of the guitar amp. Cords can become frayed after a great deal of use. Also inspect where the cord enters the amp because this is a high stress area where the cords generally break down.

Indications that Outlet and Home Electrical Wiring Should be Checked: I suspect a problem with the outlet or the wiring of the outlet circuit. The outlet circuit should be identified and turned OFF. The outlet should be removed and visually checked for damage or deterioration.

How to Wire a Switch to Battery Power Sources: You will need to select and size the switches and relay according to the voltage and amperage, or in this case mili-amps or watts of the circuit load.

The Key To Long Lasting Light Bulbs – I have two recommendations that I’m sure will help your light bulbs last longer, and this should be considered whenever light bulbs are being installed on ceiling fans and in areas where there may be a level of any type of vibration.

How to Wire a Remote Module to Control Lighting: If there is only one white on the load side of the module then the motor N is most likely a shared neutral – double check this. Just cap off the motor L as it will not be used.

Wiring for a Second Bathroom Light Fixture – The wiring that has been described in the question will allow the second light fixture to operate only when one of the switches for the 3 function bathroom fan unit is in the ON position.

How to Select the Right Wire Size for a Garage Panel: The size of the electrical wire for the panel will depend on the type of wire that is chosen and the method for the installation.

How to Bond The Ground: I Need to Place A Disconnect Between A Radial Saw And The Main Power Breaker.

How to Install Ceiling Fans and Wiring: I have a double switch on the wall, each with its own black, white, and copper coming out of it.

How to Identify and Splice Telephone System Cables – Telephone system wiring is considered low voltage however when a call comes in there could be up to 90 volts present.

Direct Burial Telephone Cable: This type of cable is a commonly installed and used for telephone service in areas such as yours. The wire is buried at least 18″ underground with out any conduit pipe.

The Basics of Light Fixture Electrical Wiring: Electrical testers enable you to identify electrical circuits and help prevent the possibility of accidental electrical shock.

Safe Amperage Ratings for Electrical Wire: The amperage rating will depend on the insulation type of the #12 AWG wire, Surpassing the amperage rating of any electrical wire is highly dangerous and not safe and can cause the wire to become over heated which could lead to a fire.

Safe Keeping for Spare Electrical Wires and Cables: Spare electrical wiring must be dealt with properly to avoid danger.

The Importance of Properly Sizing a Generator and Transfer Switch: The amperage size of the plug has internal protection in place and changing sizes of any of these parts would greatly affect the integrity of the circuit design and could cause some potential damage.

Outlet Circuit Repair for a Mobile Home: The most typical cause for part or all of an outlet circuit to stop working, or to work intermittently is due to either a deteriorating connection where the electrical wires attach to the outlet.