The electrical loads have much to do with the design of the main wire and main switch…..
If the new timer is to take the place of the existing system then you either need to identify that system and….
There should be a minimum of 12 inches separation between communications cables and power cables. Crossing at 90 degrees is….
A separate ground bar must be installed into the sub-panel where all the circuit grounds must be terminated. This will provide the required…
I suspect this is an isolated problem with that circuit or outlet…Another possibility is to have the cable company verify their ground connection for their incoming…..
A 120 volt power source must be located and installed to the desired location for the gfi outlet…
There are a few options for 4-way switching, one of which is very affordable and is very reliable….
When an electrical circuit or device fails the best way to determine what has caused the problem is to begin…..
This will provide you with more information about calculating electrical circuits….
Telephone jacks are typically wired to a standard configuration. The basic single line phone using the…
Your remote control may be limited to control the light only and not the fan. Fan speed controls are different than light controls…
Yes, you can put both wires in the same hole. Just make sure the wiring is protected in the center of the framing. Install Safety Nail Plates if needed. See the Wiring Projects link below for some pictures of installing electrical wiring and safety plates…..
There is an enormous about of useful home electrical information on this website to help you….
I see so many times where electrical projects are installed without regard to electrical codes and an understanding of some important factors….
The solution is to have new circuits installed for specific areas or devices which would eliminate the possibility of…
The concern is that an undersized or unsafe type of insulation found with most general purpose extension cords is unsafe and….