Articles about

would be OK to use in-house wiring from the GFI to the light on the pole…

When I turned the power back on the fan works but the light on the fan is now controlling the lamp plugged into the outlet. Can You Help?

I am replacing a two bulb light fixture with a ceiling fan and light. I am having trouble with the wires from the fan to the junction box, as it seems there are more wires from the ceiling.

I am switching from a gas dryer to an electric. What charge should I expect from the electrician to wire a new outlet?

Can I run a heavy extension cord under ground to plug in a fountain for a small water garden?

Question: why does my main switch red not trip when i send a fault current through it.

Question: I had to replace a kitchen electric stove. The stove that was removed was wired into the wall.

Question: We have run a coax wire from one switch to an under cabinet light fixture and it works fine.

Question: My wife and I bought a fixer upper mobile home that needs the electrical upgraded. We are upgrading the service to 150 amps.

My electrician is trying to ground my above ground pool. There is no metal on the…

Can you please tell me where I can find a dryer cord to match this outlet…

Most often this is the symptom of a deteriorating connection that is occurring most likely at the electrical…

There are two provisions that will allow this. Don’t get confused by the voltage specification of home electrical wiring in this scenario…

have the inspector tell you what category the project has been identified as. If this is not correct then you need to discuss this with him. This does not mean that you can cut corners to prevent applicable code requirements. However…

Can you convert a 220 Volt outlet into a 230 Volt outlet so a 230 Volt AC unit can be plugged in?

I have 2, 3-way switch setups each controlling 1 light fixture. I’d like to tie them together into a single 4 way system…

I need to run a 60 amp 220v cable to an air handler for a 45 ft length, should I use number 8 or 6 cable…

We’re not talking about a lot of amps, and since it won’t be plugged in all the time, is that safe?

If the screws for the terminals come all the way out, is the receptacle still good to use?

I have a small fan that calls for a 3v adapter. Can I use a 7v adapter instead?