Articles about
Bathroom Heater Electrical Wiring
How to Wire an In Wall Electric Heater – Typical Electrical Circuit Requirements for an In Wall Electric Heater, A dedicated circuit, typically 20 amps, 240 volts, verify the amperage with the size of the specific heater and the installation manual.
Wiring Diagrams for 3-Way Switches
The Key to Wiring 3-Way Switches – The Power Feed and the Switch Leg leading to the fixture(s) typically, one at each switch location, are attached to the screw terminal found at one end of the switch by itself
Installing a Electricity Cost Monitor
Where can the Clamp Modules of an Electricity Monitor be Installed? Where to Install the Clamp Modules of a Electricity Monitor.
Identifying The Source of Electrical Hazards
How to Prevent a Potential Problem with a Circuit that is not Properly Grounded: The terminations to the outlet and the connections of the power cord should be positively identified and verified. The 4 wire 240 volt outlet should have a ground wire attached to it and if the outlet box is metal or has a ground screw terminal then there should be a ground wire attached there as well ending up with a bond of all ground wires within the outlet box.
RCD and Freezer Fridge Outlets
Should freezers or fridges in the house be connected to circuits covered by an RCD…
Replacing Recessed Lights with Pendant Light Fixtures
How to Prepare and Install Pendant light Fixtures: The whole recessed light fixture can would need to be removed which would reveal the 120 volt wiring with the white, black and ground wire.
