Articles about wiring

Each air conditioner should be on its own circuit sized according to the specifications for…

I would select the one that is closest to the door, whatever that color ends up being. Just be sure to…

The advantage would be a much faster start and if the rest of the equipment requires 240 volt then it may be…

To attach these pieces taking into consideration the fragile nature of the feed through and the torque that will be applied…

If the new timer is to take the place of the existing system then you either need to identify that system and….

There should be a minimum of 12 inches separation between communications cables and power cables. Crossing at 90 degrees is….

A separate ground bar must be installed into the sub-panel where all the circuit grounds must be terminated. This will provide the required…

A 120 volt power source must be located and installed to the desired location for the gfi outlet…

Your remote control may be limited to control the light only and not the fan. Fan speed controls are different than light controls…

Yes, you can put both wires in the same hole. Just make sure the wiring is protected in the center of the framing. Install Safety Nail Plates if needed. See the Wiring Projects link below for some pictures of installing electrical wiring and safety plates…..

There is an enormous about of useful home electrical information on this website to help you….

I see so many times where electrical projects are installed without regard to electrical codes and an understanding of some important factors….

Fully explained wiring instructions and wiring diagrams can be found here….

In order to answer this question you must first identify the configuration of your existing wiring configuration including….

The wiring coming out of the wall looks like two black insulated wires and no copper or bare wires. No third wire at all…

Fully explained wiring instructions complete with a picture series of an installation and wiring diagrams can be found here in the Smoke Detector area here in this website…

I tried pretty much every combination possible to hook up a 2-light ceiling fixture in the hallway, and none are working. I found out that now the bathroom light right off that hallway is no longer working too…

I am attempting to connect it to a switch that controls a 2 plug receptacle which appears to be a end of the run circuit…

Depending on the containment of the fixtures, how far the fixtures will be apart and if the wiring will be vulnerable to damage you could either use…

The answer is yes as long as you use the right size wire nut for the size of the wires that you are splicing. To help you select the right size wirenut ….